Experimental Procedure
-
Install the insert 1 adjust the cooling water flow rate(only a very low cooling water flow rate of apporximately 1liter/hour is requied to dissipate a heater power 90w at a temp difference of 90 0 c).
-
Switch on the unit and adjust the power to 40w usinh the potentimeter of the control and dispaly unit.
-
When the thermal conduction process has reached a steady state condition,i.e. the temperature at the individual measuring points are stable and no longer changing,note the temperatures at various locations and the power supplied to the heater.
-
The same procedure holds good for all the inserts and for the liner and radial conduction.
Virtual Experimentation Procedure:
- TO RUN THIS EXPERIMENT CLICK RUN BUTTON INDICATED AS AN ARROW
INPUT PALETTE :
1. Select one of the Material from List then automatically Conductivity K shows of selected material.
2.Enter Hot End.
3.Enter Cold End.
4.Enter Radius
SIMULATION:
1. Green color Bubble is blinking (in Yellow color) means process is start.
OUTPUT PALETTE:
1. OUTPUT PALETTE shows Temperature v/s Distance Graph.